|
| ORIGINAL RESEARCH |
 |
|
|
| Year : 2013 |
Volume
: 24 | Issue : 3 | Page
: 331-335 |
|
Effect of different evaporation periods on microtensile bond strength of an acetone-based adhesive to dentin
Abdolrahim Davari1, Majid Mousvinasab1, Alireza Danesh Kazemi1, Reza Rouzbeh2
1 Department of Operative Dentistry, Member of Social Determinants of Oral Health Research Center, Dental School, Shahid Sadoughi University of Medical Sciences, Yazd, Iran
2 Private Practice, DDS, Yazd, Iran
Correspondence Address:
Majid Mousvinasab
Department of Operative Dentistry, Member of Social Determinants of Oral Health Research Center, Dental School, Shahid Sadoughi University of Medical Sciences, Yazd
Iran
 Source of Support: None, Conflict of Interest: None  | Check |
DOI: 10.4103/0970-9290.117997
|
|
|
Objective: Solvent content of a contemporary dental adhesive affect the bonding process, especially in the case of acetone based adhesives. The aim of this study was to evaluate the effect of different air-drying periods on microtensile bond strength (MTBS) of a total-etch adhesive to dentin.
Materials and Methods: Prime & Bond NT (Dentsply-USA) was used with different air-drying periods (0, 2, 5, 10, 30sec) for bonding a composite resin to prepared dentin. The specimens were then subjected to a tensile force until fracture and the MTBSs of the samples were recorded. Failure modes of the fractured samples were also determined using stereomicroscope and scanning electron microscopy. Data were analyzed using ANOVA and Bonferroni tests (P = 0.05).
Results: With increasing the air-drying periods, the MTBSs were increased until the 5 second air-blowing; after that, with increasing the air-drying periods, the MTBSs decreased. Both, the most complicated failure and the strongest bond were seen in the 5 sec air-drying group. Conclusion: There is an optimum air-drying time for acetone based adhesives which results in the strongest bond to dentin. |
|
|
|
| [FULL TEXT] [PDF]* |
|
 |
|
Users online:
